2×2 ribbed hat
A fitted hat knit in the round, ribbed all the way. The crown narrows over four decrease rounds, then the last stitches are gathered closed.
Knit it in mitaine. Pick your size or give your measurements: only your numbers show, and the counter follows each step.
Open the pattern in your browserSizes
Child, Adult S and Adult L: numbers are given in this order, for example “80 (96, 104)”.
| Child | Adult S | Adult L | |
|---|---|---|---|
| Fits | Head 46 to 51 cm | Head 53 to 56 cm | Head 56 to 61 cm |
| A · Circumference, unstretched | 40 cm | 48 cm | 52 cm |
| B · Height | 18 cm | 21 cm | 23 cm |
Supplies
- Aran weight yarn, 110 (150, 180) m. Soft wool: merino, or wool and alpaca.
- Circular needle 4.5 mm, 40 cm
- Double-pointed needles 4.5 mm · for the crown
- 1 stitch marker
- Tapestry needle
Gauge
20 sts × 26 rounds = 10 cm in 2×2 rib slightly stretched, 4.5 mm needles.
Abbreviations
- CO
- cast on
- st, sts
- stitch, stitches
- pm
- place marker
- BOR
- beginning of round
- k
- knit
- p
- purl
- rib
- ribbing
- dpn
- double-pointed needles
- k2tog
- knit two together
- p2tog
- purl two together
Ribbing
With the 4.5 mm circular needle, loosely cast on 80 (96, 104) sts.
Place a marker for the beginning of round and join in the round without twisting: the cast on edge must stay inside the needle and never spiral around it.
Repeat k2, p2 to the end of the round. Continue in 2×2 rib until the hat measures 14 (17, 19) cm from the cast on edge.
Crown
As the crown narrows, switch to double-pointed needles once the stitches stretch around the circular needle.
Decreases 1
Repeat k2, p2tog to the end of the round. 60 (72, 78) sts remain.
Repeat k2, p1 to the end of the round. Work 3 rounds like this.
Decreases 2
Repeat k2tog, p1 to the end of the round. 40 (48, 52) sts remain.
Repeat k1, p1 to the end of the round. Work 2 rounds like this.
Decreases 3
K2tog to the end of the round. 20 (24, 26) sts remain.
Knit 1 round.
Decreases 4
K2tog to the end of the round. 10 (12, 13) sts remain.
Finishing
Cut the yarn 20 cm long. With a tapestry needle, thread it through the 10 (12, 13) remaining sts, slipping them off the needles, then a second time. Pull tight and fasten off on the inside.
Weave in the cast on tail. Hand wash the hat and dry it flat.
Made to measure
In mitaine, this pattern also has a made-to-measure size: give head circumference and height, and your gauge if you like. Stitches, rounds and yardage are worked out again, and only your numbers show. The hat is knit about 12% smaller than your head: ribbing stretches. The stitch count rounds to a multiple of 8 so the crown works out. Open the pattern in your browser.
An original pattern written for mitaine, free for personal use. Source: Craft Yarn Council www.YarnStandards.com